Your - LH6 - is a Lamp Holder with 6 inches wire leads and is also known as EZCONEX™.

EZCONEX™ - "A easy way to change a lamp without getting under the layout." 

This lamp holder has unique 3-finger design terminals. It will mate and hold round, square or rectangular leads.

EZCONEX could easily be permanently mounted on the layout.

LH6 supports the following lamps and LED's:

INSTALLATION:                                                      

• Measure 7/16 inch from the bottom of the Lamp or LED and mark.
• Cut the Lamp or LED leads using a pair of sharp lead cutters.
• Carefully insert the lamp or the LED into the LH6.
• Connect LH6 assembly to your circuit. 

Note:  If you are using LED's check the polarity before connecting to your circuit.

WHERE TO USE -  Let your imagination create unique designs to fit your needs.

• Buildings interior lighting.
• Create a flood light. Use a small piece of aluminum foil and a pencil to create the cone shape.
• Insert multiple lamps and create a dinning room chandelier.
• A front porch ceiling fan. Use Elmer's glue and toothpicks to make the fan blades.
• Make multicolor clusters.
• Create outdoor ornamental lights.
• Make your own miniature light rope.

Note: Most of the above suggestions are for lamps only. Leads are smaller and easier to work with.

         Ensure that all lamps are connected in parallel. Insulate exposed leads to prevent shorting. 

         If you need more information please contact us.  

WARRANTY - 2 YEAR FROM DATE OF PURCHASE

CARE - To enjoy your LH6 for a long time:

• Keep it dry. If it gets wet, wipe it dry immediately.
• Use and store the LH6 only in normal temperature environments.
• Handle the LH6 gently and carefully. Do not pull the wires from the holder.
• Keep the LH6 away from dust and dirt.

MODIFYING OR TAMPERING WITH THE LH6 INTERNAL COMPONENTS CAN CAUSE A MALFUNCTION AND WILL INVALIDATE ITS WARRANTY.

SPECIFICATIONS

Copyright © Train Set Electronics. All rights reserved.